Internet-Draft ECH in SVCB May 2024
Schwartz, et al. Expires 24 November 2024 [Page]
Workgroup:
TLS Working Group
Internet-Draft:
draft-ietf-tls-svcb-ech-02
Published:
Intended Status:
Standards Track
Expires:
Authors:
B. Schwartz
Meta Platforms, Inc.
M. Bishop
Akamai Technologies
E. Nygren
Akamai Technologies

Bootstrapping TLS Encrypted ClientHello with DNS Service Bindings

Abstract

To use TLS Encrypted ClientHello (ECH) the client needs to learn the ECH configuration for a server before it attempts a connection to the server. This specification provides a mechanism for conveying the ECH configuration information via DNS, using a SVCB or HTTPS record.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 24 November 2024.

Table of Contents

1. Overview

The Service Bindings framework [SVCB] allows server operators to publish a detailed description of their service in the Domain Name System [RFC1034] using SVCB or HTTPS records. Each SVCB record describes a single "alternative endpoint", and contains a collection of "SvcParams" that can be extended with new kinds of information that may be of interest to a client. Clients can use the SvcParams to improve the privacy, security, and performance of their connection to this endpoint.

This specification defines a new SvcParam to enable the use of TLS Encrypted ClientHello [ECH] in TLS-based protocols. This SvcParam can be used in SVCB, HTTPS or any future SVCB-compatible DNS records, and is intended to serve as the primary bootstrap mechanism for ECH.

2. SvcParam for ECH configuration

The "ech" SvcParamKey is defined for conveying the ECH configuration of an alternative endpoint. It is applicable to all TLS-based protocols (including DTLS [RFC9147] and QUIC version 1 [RFC9001]) unless otherwise specified.

In wire format, the value of the parameter is an ECHConfigList (Section 4 of [ECH]), including the redundant length prefix. In presentation format, the value is the ECHConfigList in Base 64 Encoding (Section 4 of [RFC4648]). Base 64 is used here to simplify integration with TLS server software. To enable simpler parsing, this SvcParam MUST NOT contain escape sequences.

3. Server behavior

When publishing a record containing an "ech" parameter, the publisher MUST ensure that all IP addresses of TargetName correspond to servers that have access to the corresponding private key or are authoritative for the public name. (See Section 7.2.2 of [ECH] for more details about the public name.) Otherwise, connections will fail entirely.

4. Client behavior

This section describes client behavior in using ECH configurations provided in SVCB or HTTPS records.

4.1. Disabling fallback

The SVCB-optional client behavior specified in (Section 3 of [SVCB]) permits clients to fall back to a direct connection if all SVCB options fail. This behavior is not suitable for ECH, because fallback would negate the privacy benefits of ECH. Accordingly, ECH-capable SVCB-optional clients MUST switch to SVCB-reliant connection establishment if SVCB resolution succeeded (as defined in Section 3 of [SVCB]) and all alternative endpoints have an "ech" SvcParam.

4.2. ClientHello construction

When ECH is in use, the TLS ClientHello is divided into an unencrypted "outer" and an encrypted "inner" ClientHello. The outer ClientHello is an implementation detail of ECH, and its contents are controlled by the ECHConfig in accordance with [ECH]. The inner ClientHello is used for establishing a connection to the service, so its contents may be influenced by other SVCB parameters. For example, the requirements related to ALPN protocol identifiers in Section 7.1.2 of [SVCB] apply only to the inner ClientHello. Similarly, it is the inner ClientHello whose Server Name Indication identifies the desired service.

4.3. Performance optimizations

Prior to retrieving the SVCB records, the client does not know whether they contain an "ech" parameter. As a latency optimization, clients MAY prefetch DNS records that will only be used if this parameter is not present (i.e. only in SVCB-optional mode).

The "ech" SvcParam alters the contents of the TLS ClientHello if it is present. Therefore, clients that support ECH MUST NOT issue any TLS ClientHello until after SVCB resolution has completed. (See Section 5.1 of [SVCB]).

5. Interaction with HTTP Alt-Svc

HTTP clients that implement both HTTP Alt-Svc [RFC7838] and the HTTPS record type [SVCB] can use them together, provided that they only perform connection attempts that are "consistent" with both sets of parameters (Section 9.3 of [SVCB]). At the time of writing, there is no defined parameter related to ECH for Alt-Svc. Accordingly, a connection attempt that uses ECH is considered "consistent" with an Alt-Svc Field Value that does not mention ECH.

Origins that publish an "ech" SvcParam in their HTTPS record SHOULD also publish an HTTPS record with the "ech" SvcParam for every alt-authority offered in its Alt-Svc Field Values. Otherwise, clients might reveal the name of the server in an unencrypted ClientHello to an alt-authority.

If all HTTPS records for an alt-authority contain "ech" SvcParams, the client MUST adopt SVCB-reliant behavior (as in Section 4.1) for that RRSet. This precludes the use of certain connections that Alt-Svc would otherwise allow, as discussed in Section 9.3 of [SVCB].

5.1. Security Considerations

A SVCB RRSet containing some RRs with "ech" and some without is vulnerable to a downgrade attack: a network intermediary can block connections to the endpoints that support ECH, causing the client to fall back to a non-ECH endpoint. This configuration is NOT RECOMMENDED. Zone owners who do use such a mixed configuration SHOULD mark the RRs with "ech" as more preferred (i.e. lower SvcPriority value) than those without, in order to maximize the likelihood that ECH will be used in the absence of an active adversary.

Use of ECH yields an anonymity set of cardinality equal to the number of ECH-enabled server domains supported by a given client-facing server. Thus, even with an encrypted ClientHello, an attacker who can enumerate the set of ECH-enabled domains supported by a client-facing server can guess the correct SNI with probability at least 1/K, where K is the size of this ECH-enabled server anonymity set. This probability may be increased via traffic analysis or other mechanisms.

An attacker who can prevent SVCB resolution can deny clients any associated security benefits. A hostile recursive resolver can always deny service to SVCB queries, but network intermediaries can often prevent resolution as well, even when the client and recursive resolver validate DNSSEC and use a secure transport. These downgrade attacks can prevent a client from being aware that "ech" is configured which could result in the client sending the ClientHello in cleartext. To prevent downgrades, Section 3.1 of [SVCB] recommends that clients abandon the connection attempt when such an attack is detected.

6. IANA Considerations

IANA is instructed to modify the Service Binding (SVCB) Parameter Keys Registry entry for "ech" as follows:

Table 1
Number Name Meaning Format Reference Change Controller
5 ech TLS Encrypted ClientHello Config (This document) IETF

7. References

7.1. Normative References

[ECH]
Rescorla, E., Oku, K., Sullivan, N., and C. A. Wood, "TLS Encrypted Client Hello", Work in Progress, Internet-Draft, draft-ietf-tls-esni-18, , <https://datatracker.ietf.org/doc/html/draft-ietf-tls-esni-18>.
[RFC1034]
Mockapetris, P., "Domain names - concepts and facilities", STD 13, RFC 1034, DOI 10.17487/RFC1034, , <https://www.rfc-editor.org/rfc/rfc1034>.
[RFC4648]
Josefsson, S., "The Base16, Base32, and Base64 Data Encodings", RFC 4648, DOI 10.17487/RFC4648, , <https://www.rfc-editor.org/rfc/rfc4648>.
[SVCB]
Schwartz, B. M., Bishop, M., and E. Nygren, "Service Binding and Parameter Specification via the DNS (SVCB and HTTPS Resource Records)", Work in Progress, Internet-Draft, draft-ietf-dnsop-svcb-https-12, , <https://datatracker.ietf.org/doc/html/draft-ietf-dnsop-svcb-https-12>.

7.2. Informative References

[RFC7838]
Nottingham, M., McManus, P., and J. Reschke, "HTTP Alternative Services", RFC 7838, DOI 10.17487/RFC7838, , <https://www.rfc-editor.org/rfc/rfc7838>.
[RFC9001]
Thomson, M., Ed. and S. Turner, Ed., "Using TLS to Secure QUIC", RFC 9001, DOI 10.17487/RFC9001, , <https://www.rfc-editor.org/rfc/rfc9001>.
[RFC9147]
Rescorla, E., Tschofenig, H., and N. Modadugu, "The Datagram Transport Layer Security (DTLS) Protocol Version 1.3", RFC 9147, DOI 10.17487/RFC9147, , <https://www.rfc-editor.org/rfc/rfc9147>.

Authors' Addresses

Ben Schwartz
Meta Platforms, Inc.
Mike Bishop
Akamai Technologies
Erik Nygren
Akamai Technologies