The purpose of this working group is to define and develop a standard virtual router redundancy protocol for IPv4 and IPv6. A virtual router redundancy protocol is a protocol which allows several routers on a multiaccess link to utilize the same virtual IP address. One router will be elected as a master with the other routers acting as backups in case of the failure of the master router. The primary motivation to using a virtual router redundancy protocol is that host systems may be configured (manually or via DHCP) with a single default gateway, rather than running an active routing protocol. The protocol should also support the ability to load share traffic when both routers are up. The goals of this working group are: 1. Define and develop a standard virtual router redundancy protocol for IPv4 and IPv6. 2. Develop VRRP MIB(s). 3. Separate specifications will be developed for IPv4 and IPv6. 4. Determine whether static (configuration based) load sharing is adequate or if some amount of dynamic load sharing is required. 5. Working group will examine security issues to determine what security threats it is appropriate for the VRRP protocol to handle and include the appropriate mechanisms in the VRRP protocol. 6. The internet draft "Virtual Router Redundancy Protocol" (draft-hinden-vrrp-00.txt) will be use as the basis of virtual router redundancy protocol. The working group will also consider other Internet-Drafts related to this topic allowing for issues regarding change control, security, running code, etc. 7. Intellectual property issues regarding the technology to develop a virtual router redundancy protocol will be identified and addressed.